sacoratelfare850 sacoratelfare850

06-03-2020
Computers and Technology

contestada

In the process of installing a V-belt drive system, the motor and driven component should be checked for a soft foot condition and excessive run-out. The shaft run-out should be no more than __________.

Respuesta :

FreshPrinxce FreshPrinxce

07-03-2020

Answer:

0.005"

Explanation:

In general, Sheave face or shaft runout should be no more than 0.005 inchea; up to 5 inches sheave or shaft, and 1 mil per inch diameter for larger sheaves or shaft.

Rim or groove runout can not be easily be measured in most cases.

Cheers

Answer Link

Otras preguntas

________ the climate ___________, there _________ be floods in some areas, and not enough _____________ will fall on others. This will___________ a serious effe

Which situation describes negative peer pressure? Which scenario best demonstrates empathy?

This allele is only expressed when two copies are present. *

. Where are most rice crops raised in China? A. in North China Plain B. north and west of the Tibetan Plateau C. along the eastern coastline D. in southeastern

Find the length of the third side to the nearest tenth

Please help me with this question! (Correct answers only. Don’t answer if you aren’t sure)

¿Qué número sigue? 1; 1; 3; 15; 105;

Im trying to figure out how to answer the immigrant worksheet

Citizens ask leaders about their decisions and if its citizens disagree they can eject the leaders out of office

A company bought $1,150,000 of equipment with an expected life of 28 years and no residual value. After 24 years the company sold the equipment for $128,500. I